1. Printer Compatibility

• Use only with DTF printers equipped with suitable printheads (commonly Epson-based Micro Piezo printheads).

• Ensure your printer firmware and RIP software are configured for DTF printing.

2. Shake Well Before Use

• Gently shake DTF ink bottles for 30–60 seconds before filling the ink tanks.

• Regular shaking ensures even pigment distribution, especially for white ink.

3. Printer Preparation

• Clean printheads, capping stations, and dampers if switching from another ink brand.

• Perform nozzle checks and head cleanings before starting.

4. Printing Process

• Print your design directly onto specialized DTF film.

• Use mirror image printing mode if needed.

• Maintain optimal temperature and humidity (recommended: 68–77°F, 40–60% RH) for best results.

5. Applying Adhesive Powder

• While ink is still wet, sprinkle DTF hot-melt adhesive powder evenly across the printed design.

• Shake off excess powder carefully.

6. Curing

• Cure the powdered film using a heat press, curing oven, or heat gun:

  • Recommended curing temperature: 250–300°F (120–150°C)

  • Curing time: 2–3 minutes until adhesive melts evenly and becomes matte.

7. Heat Transfer to Garment

• Pre-press your fabric for 5 seconds to remove moisture and wrinkles.

• Place the cured DTF film on the garment (design facing down).

• Press at 300–320°F (150–160°C) for 10–15 seconds with medium pressure.

8. Peel

• Allow the transfer to cool down (cold peel recommended unless otherwise stated).

• Gently peel off the film.

9. Post-Press (Optional for Durability)

• For better wash resistance, press the garment again for 5–10 seconds with a protective sheet (parchment paper or Teflon).

Important Tips:

• Regularly agitate white ink inside the printer system to avoid pigment settling.

• Maintain clean nozzles for sharp prints.

• Store ink in a cool, dry place away from direct sunlight.